1 Preface
1-2 NetPath 100 User’s Manual - Installation Guide 980-001-0210G
June
1999
Special
Instructions
The following are to be performed by qualified service personnel ONLY.
When installing NetPath 100 equipment, observe the following precautions:
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless a jack is specifically designed
for wet locations.
3. Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
WARNING
NO OPERATOR SERVICEABLE PARTS ARE INSIDE THIS
EQUIPMENT. SERVICE MUST BE PERFORMED BY QUALIFIED
SERVICE PERSONNEL.
ATTENTION
CET APPAREIL NE CONTIENT AUCUN EL
MENT QUE
L’UTILISATEUR PUISSE R
PARER. CONFEIR LA MAINTENACE
UN PERSONNEL TECHNIQUE QUALIFI
.
Do not expose the NetPath 100 to moisture, excessive heat or bright sunlight, vibra-
tion, sudden impact, or voltage surges.
UNPACKING AND HANDLING
When you receive the equipment, inspect the exterior of the shipping container for
signs of obvious damage. If the container is damaged, inform the local carrier that
they may be subject to a claim.
As you unpack the equipment, check for physical damage and conformance to the
packing list. If the equipment is damaged or does not conform to the packing list,
please inform Control Resources Corporation immediately.
Avoid Moisture
Avoid Direct Sunlight/Heat
Avoid Vibration/Sudden Impact Avoid Voltage Surges
To Next Page
Loading...