5 Diagnostics
980-001-0210G NetPath 100 User’s Manual - Installation Guide 5-11
June
1999
Network and User (headings):
Network - Statistics representing traffic received from the frame switch.
User - Statistics representing traffic received from the DTE (router).
The Frame Relay traffic parameters displayed for Network and User are:
LTO: LMI Timeouts - Count of LMI timeouts detected for the interval.
LFE: LMI Frame Errors - Count of LMI Frame Errors detected for the interval.
DFES: Data Frame Errored Seconds - Count of seconds during which the unit’s
Frame Manager detects an Errored data frame.
NOTE: When the “LMI Protocol” is set to “None,” the values for LTO and LFE
will be (blank).
Current - Displays the total count for each of the performance parameters within the
current 15-minute interval.
24 Hour - Displays the total counts for each of the performance parameters over all
valid history intervals (does not include current interval).
Additional commands on this screen are:
ResetStats [RS] - Clears all counters (including 24 hour history).
ViewHistory [VH current_time (optional)] - Advances to Page 1 of the
Frame Manager Statistics History screen.
The “current_time” optional parameter causes the history interval count to reflect
the actual time-of-day rather than a simple count of intervals. The entry is in 24-
hour format, using three or four digits. Example: 1445 = 2:45 PM.
To Next Page
Loading...