ZKTeco SC800 - Page 40

SC800 User Manual
Page | 39 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
password in the password interface, and then tap M/OK.
 When the WIFI is connected successfully, the initial interface will display the
Wi-Fi logo.
 Adding Wi-Fi Network Manually
The Wi-Fi can also be added manually if the required Wi-Fi does not show on
the list.
Note: After successfully adding the WIFI manually, follow the same process to
search for the added Wi-Fi name.
WIFI Enabled: Tap on the
required network from the
searched network list.
Tap on the password field to
enter the password and tap
M/OK.
Tap on Add Wi-Fi Network to
add the Wi-Fi manually.
On this interface, enter the Wi-Fi
network parameters. (The added
network must exist.)