ZKTeco SC800 User Manual

SC800 User Manual
Page | 93 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
18 Connect to BioTime 8.0 Software
Set the Communication Address 18.1
1. Tap COMM. > Ethernet in the main menu to set the IP address and
gateway of the device.
(Note: The IP address should be able to communicate with the ZKBioTime
8.0 server, preferably in the same network segment with the server address)
2. In the main menu, click COMM. > Cloud Server Setting to set the server
address and server port.
Server address: Set the IP address as of ZKBioTime 8.0 server.
Server port: Set the server port as of ZKBioTime 8.0 server.
Add Device on the Software 18.2
Add the device by searching. The process is as follows:
1. Click Device > Device > Add, to add the device on the software.
2. A new window pops-up on clicking [Add]. Enter the required information
about the device and click [Confirm], then the added devices are displayed
automatically.

ZKTeco SC800 Specifications

General

Brand	ZKTeco
Model	SC800
Category	IP Access Controllers
Language	English