SC800 User Manual
Page | 48 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
Tap Date and Time Auto Sync to enable automatic time synchronization
based on the service address you enter.
Tap Set the NTP Server Address to manually set the date and time and
then tap to Confirm and save.
Tap Select Time Zone to manually select the time zone where the device
is located.
Enable or disable this format by tapping 24-Hour Time. If enabled, then
select the Date Format to set the date.
Tap Daylight Saving Time to enable or disable the function. If enabled,
tap Daylight Saving Mode to select a daylight-saving mode and then
tap Daylight Saving Setup to set the switch time.
Week Mode Date Mode
When restoring the factory settings, the time (24-hour) and date format
(YYYY-MM-DD) can be restored, but the device date and time cannot be
restored.