SC800 User Manual
Page | 60 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
automatically switch to a specific punch status
according to the predefined time schedule
which can be set in the Shortcut Key Mappings.
Manual and Auto Mode: The main interface
will display the auto-
However, the users will still be able to select
alternative that is the manual attendance status.
After timeout, the manual switching to punch
state key will become auto-switch punch state
key.
Manual Fixed Mode: After the punch state key
is set manually to a particular punch status, the
function will remain unchanged until it is being
manually switched again.
Fixed Mode:
Only the manually fixed punch
state key will be shown. Users cannot change
the status by taping any other keys.
Punch State Timeout(s)
It is the time for which the punch state displays.
The value ranges from 5 to 999 seconds.
Punch State Required
Select whether an attendance state needs to be
selected after verification.
ON: Attendance state needs to be selected after
verification.
OFF: Attendance state need not requires to be
selected after verification.
To Next Page
Loading...
Need help?
General
