ZKTeco SC800 User Manual

SC800 User Manual
Page | 62 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
 If the Shortcut key is set as a punch state key (such as check in, check out,
etc.), then it is required to set the punch state value (valid value 0 to 250),
name.
 Set the Switch Time
 The switch time is set in accordance with the punch state options.
 When the Punch State Mode is set to Auto Mode, the switch time
should be set.
 On the Shortcut Key interface, tap Set Switch Time to set the switch
time.
 On the Switch Cycle interface, select the switch cycle (Monday, Tuesday,
etc.) as shown in the image below.
 Once the Switch cycle is selected, set the switch time for each day, and
tap OK to confirm, as shown in the image below.
Note: When the function is set to Undefined, the device will not enable the
punch state key.

ZKTeco SC800 Specifications

General

Brand	ZKTeco
Model	SC800
Category	IP Access Controllers
Language	English