Chapter 20 Classifier
VES1724-56 User’s Guide
196
Layer 2
Specify the fields below to configure a layer 2 classifier.
VLAN Select Any to classify traffic from any VLAN or select the second option and specify the source
VLAN ID in the field provided.
Priority Select Any to classify traffic from any priority level or select the second option and specify a
priority level in the field provided.
Ethernet
Type
Select an Ethernet type or select Other and enter the Ethernet type number in hexadecimal
value. Refer to Table 83 on page 198 for information.
Source
MAC
Address
Select Any to apply the rule to all MAC addresses.
To specify a source, select the second choice and type a MAC address in valid MAC address format
(six hexadecimal character pairs).
This field is not configurable if you set IP Type to IPv6.
Port Type the port number to which the rule should be applied. You may choose one port only or all
ports (Any).
Destination
MAC
Address
Select Any to apply the rule to all MAC addresses.
To specify a destination, select the second choice and type a MAC address in valid MAC address
format (six hexadecimal character pairs).
This field is not configurable if you set IP Type to IPv6.
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP Select Any to classify traffic from any DSCP or select the second option and specify a DSCP
(DiffServ Code Point) number between 0 and 63 in the field provided.
IP Protocol Select an IP protocol type or select Other and enter the protocol number in decimal value. Refer
to Table 84 on page 198 for more information.
You may select Establish Only for TCP protocol type. This means that the Switch will pick out the
packets that are sent to establish TCP connections.
The Establish Only option is not selectable if you set IP Type to IPv6.
IP Type Select to configure an IPv4 or IPv6 address.
Source
IP
Address/
Address
Prefix
Enter a source IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
An IPv4 subnet mask can be represented in a 32-bit notation. For example, the subnet mask
“255.255.255.0” can be represented as “11111111.11111111.11111111.00000000”, and
counting up the number of ones in this case results in 24.
Socket
Number
Note: You must select either UDP or TCP in the IP Protocol field before you configure the socket
numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option
and enter a TCP/UDP protocol port number. Refer to Table 85 on page 198 for more information.
Destination
Table 81 Advanced Application > Classifier (continued)
LABEL DESCRIPTION
To Next Page
Loading...
