193D Systems, Inc.
NOTE: The printer will begin the Auto Level procedure. This may
take a few minutes.
NOTE: If the print pad is not level, remove the print pad and select
the checkmark to continue. The print pad is magnetically attached to
the adjustment knobs. To remove it, lift up the front of the print pad
and pull it out of the printer.
NOTE: Follow the instructions on the touchscreen display. Use the
included 1.5 mm Allen wrench to loosen the lock screws securing
the adjustment knobs to the bracket before turning the knobs. Select
the checkmark to continue.
NOTE: The lock screw (1) is located just below the adjustment knob
(2). The lock screw for adjustment knob B can be accessed from the
front of the printer. The lock screw for adjustment knob A can be
accessed from behind the printer.
NOTE: Follow the instructions on the touchscreen display. Once the
adjustments have been made, select the checkmark to continue.
1
2
To Next Page
Loading...
