283D Systems, Inc.
7
PRINTING YOUR CREATION
There are many 3D creations available at www.cubify.com. In addition, you can create your own with Cubify Invent and Cubify Sculpt
software available at www.cubify.com. The printer can only print .cube3 les. Other le formats like .stl must be processed through
Cubify software before they can be printed.
For more information about converting other 3D les to .cube3 print les, refer to the section titled Cubify Software.
PRINTING PROCEDURE
The following procedure illustrates how to print a creation.
Caution: Ensure the print pad is clean before printing.
NOTE: For best results, perform the Auto Level and Auto Gap procedures before your rst print.
NOTE: After every 10 prints, the printer will prompt you to perform the Auto Level and Auto Gap procedures.
1. After powering on your printer, press the touchscreen to begin.
2. Select PRINT.
NOTE: If the le is saved on a USB mass storage device, insert the
device into the USB inlet port on the printer.
NOTE: You may also send the le from Cubify software to the
printer using a wireless connection. Wireless transfer of print les
usually takes more time than USB mass storage device transfer.
3. Using the arrows, navigate to the le name of your creation. Select PRINT.
NOTE: The le name will appear at the top of the display.
To Next Page
Loading...
Need help?
General
