3D Systems CUBE - Print Settings Configuration

493D Systems, Inc.
Print Settings
Print Settings allow you to set the parameters of your print and build them into your print le. There are four (4) different options for
setting the print parameters.
Presets
• Draft A print that does not require strength or ne details.
• Standard A strong print that does not require ne details.
• Premium A strong print that requires ne details.
• Custom Allows you to set the layer thickness, density, and ll pattern. You may also enable or disable
supports and rafts.
Layers
• 0.070 mm High quality prints
• 0.200 mm Shorter print time
Density
• Hollow Short print times and low material use
• Strong Stronger prints
• Almost Solid High material use and almost solid prints
Fill Pattern
• Honeycomb Used for strong prints
• Diamonds For general printing
• Lines Shorter print time
A
B
C
D