1133D Systems, Inc.
4. When prompted, press and release the power button and wait until the display
turns on.
NOTE: It may take a minute for the display to turn on.
5. Perform the Auto Level and Auto Gap procedures.
NOTE: For more information, refer to the section titled Print Pad
Calibration.
REPACKING THE PRINTER
If the printer should ever need to be transported, the printer must be properly repackaged using the original packaging materials. If
you no longer have your original packaging materials, contact cubifysupport@cubify.com for assistance in obtaining the appropriate
packaging materials.
NOTE: Material cartridges should be properly removed from the printer before the printer is repacked.
1. Power off the printer by pressing and holding the button next to the touchscreen
display.
2. Disconnect the power cord from utility power and disconnect the cord from the
power supply.
3. Disconnect the power supply cable from the printer’s power inlet (A).
NOTE: The power supply cable is designed to lock in place. To
remove the cable, pull the outer sleeve back to unlock it and then
continue to pull the cable from the printer.
4. Securely repack all of the accessories into the accessories box. Place the
accessories box inside the original printer box.
NOTE: Refer to the contents list in the section titled Unpacking and
Setting Up Your Cube.
A
To Next Page
Loading...
Need help?
General
