3D Systems CUBE User Manual

793D Systems, Inc.
10
OPERATION PROCEDURES
APPLYING CUBE GLUE
Cube Glue contains water-soluble glue that adheres the part to the print pad. It is important that glue is applied to the print pad before
starting any print to ensure that the creation does not move during the printing process.
Cube Glue contains a foam applicator under the cap. It is recommended that the bottle is turned upside-down with the cap on to allow
the glue to settle into the applicator before applying.
For best results, apply two thin layers of glue to the print pad using slow circular motions when prompted by the touchscreen display.
Apply the glue in an overlapping pattern. The coverage dimensions should be larger than the footprint of the creation you are printing.
Layer 1
Apply a thin layer of glue to the print pad following the illustration below:
Layer 2
Apply a second thin layer of glue to the print pad following the illustration below:
NOTE: For best results, allow the glue to dry before printing.

3D Systems CUBE Specifications

General

Print technology	Plastic Jet Printing (PJP)
Printing material	ABS, Polylactic acid (PLA)
Number of printing colors	16
Maximum build size (WxDxH)	- mm
Plug and Play	Yes
USB version	2.0
Ethernet LAN	No
Card reader integrated	-
Product color	Silver