3D Systems CUBE User Manual

843D Systems, Inc.
NOTE: If the printer could not connect to the network, you will be
directed to enter the passcode again.
NOTE: If the printer could not connect to the network, you will be
prompted to connect to a different network.
NOTE: The printer will indicate that it has successfully connected to
a network.
Connect To An Ad Hoc Network
An ad hoc network is a temporary yet direct connection between a computer or device and the printer. It does not connect through a
router or base station and the data transfer rates are slower than the transfer rate of a standard wireless network. The computer or
device you wish to connect ad hoc to the printer must have an ad hoc adapter installed. An ad hoc network is deleted when the user
has disconnected from it or is out of range of other devices on the network unless it has been made a permanent network.
1. Select SETUP.

3D Systems CUBE Specifications

General

Print technology	Plastic Jet Printing (PJP)
Printing material	ABS, Polylactic acid (PLA)
Number of printing colors	16
Maximum build size (WxDxH)	- mm
Plug and Play	Yes
USB version	2.0
Ethernet LAN	No
Card reader integrated	-
Product color	Silver