323D Systems, Inc.
8
FINISHING YOUR CREATION
REMOVING YOUR CREATION FROM THE PRINT PAD
CAUTION: Before attempting to remove your creation from the print pad, ensure that the printer has nished
printing. Once printing has completed, the print platform and print pad will move to the bottom of the printer.
1. Grasp the front of the print pad, lift upward and remove it from the print platform.
2. Submerge the print pad and the base of the part in warm water for ten (10) minutes.
NOTE: If the part does not release from the print pad easily, allow the part to soak longer.
NOTE: IF you can not submerge the print pad in warm water, run hot water over the base of the part for ten (10)
minutes. If the part still does not release easily from the print pad after ten (10) minutes, continue to run hot
water over the part.
3. Using a rounded scraper, gently release your creation from the print pad.
CAUTION: Always move the scraper away from the body. The scraper
can cause injury if not used correctly.
NOTE: The appearance of your scraper may differ from the
illustration.
CAUTION: Exercise caution when using a tool to remove a part so
the print pad is not damaged or gouged.
4. Rinse your creation under hot water to ensure all of the glue has been removed.
5. Rinse the print pad under water to clean off any remaining glue.
6. Dry the print pad completely before reinstalling it into the printer.
CAUTION: Failure to completely dry the print pad before reinstalling it into the printer can damage sensitive
electrical components and void the manufacturer’s warranty.
Removing Rafts
A raft is the at support structure that is attached to the base of your creation if you enabled that option when generating the .cube3 le.
Although it is recommended that parts are generated and printed without rafts, some larger, more complicated parts may require one.
ABS Raft / PLA Part • ABS rafts can be peeled away from PLA parts.
PLA Raft / ABS Part • PLA rafts can be pulled from ABS parts
ABS Raft / ABS Part • Use pliers to pull away as much of the raft as possible. Then use a rough-grade sandpaper to remove
the remaining raft material, followed by a ne-grade wet and dry sandpaper to achieve a smoother
nish.
PLA Raft / PLA Part • Use pliers to pull away as much of the raft as possible. Then use a rough-grade sandpaper to remove
the remaining raft material, followed by a ne-grade wet and dry sandpaper to achieve a smoother
nish.
To Next Page
Loading...
Need help?
General
