893D Systems, Inc.
PRINT PAD CALIBRATION
Print pad calibration is performed at the factory but should be performed routinely to ensure quality printing. The printer may
occasionally prompt you to perform the Auto Level and Auto Gap procedures. If your creations are not printing as expected, check the
level of the print pad. Once Auto Level has been performed, perform the Auto Gap procedure.
NOTE: Auto Level should always be performed before the Auto Gap procedure.
NOTE: Auto Level should be performed when the printer is positioned away from bright lights or direct sunlight.
Auto Level
1. Navigate to the Print Plate Calibration screen and select AUTO LEVEL.
2. Clean the print pad thoroughly removing all glue and debris. Select the
checkmark to continue.
NOTE: The surface of the print pad must be completely clean.
NOTE: The Auto Level procedure will begin.
3. Once the Auto Level procedure has completed, select the checkmark to verify
the Z-Gap (Step 8). If the print pad is out of range, continue with the procedure.
To Next Page
Loading...
