Basic Steps for Creating a Unit
www.3ware.com 21
4 If you plan to make changes to your configuration and need to backup
data before continuing, press ESC and do so now. Otherwise, press any
key to continue.
Figure 7. Warning Message When you Start 3BM
To select the drives and create a disk unit
1 Select the drives to be included by highlighting each one and pressing
Enter to select it.
When you select a drive, an asterisk appears next to it in the left-most
column (see Figure 8).
You may include from one to sixteen drives in the unit, depending on the
number available.
Figure 8. Asterisks Next to Selected Drives
2 After all drives for the unit are selected, use the Tab to move to the
Create Unit button and press Enter.
The Create Disk Array screen appears (see Figure 9).
To Next Page
Loading...
