• Hexa by user: the user-bits are manually entered the same way as to other metadatas (scene,
take...)
• Hexa LTC: The field is automatically updated with incoming LTC User-bits, at each Jam.
Jam can be activated pressing F3 or at each new record in external LTC
• Tape ref Ascii: the first 4 characters of tape ID rare encoded as ASCII characters
(e.g. A123 will be inserted in User-bits as 41313233 'A'=41 '1'=31 ...)
• Tape ref. hexa: The first 4 characters NNNN set 0000NNNN User-Bits (numeric value are
recommended).
• Date BCD: Audio date automatically sets up the User-Bits field with iso format.
(e.g. Audio date 25/02/2016 will be inserted as 25021600 User-Bits).
6. Timecode Fudged
The audio-file time stamps correct the TC flaw of some HD cameras.
WARNING: TC will be artificially shifted of 60 ms.
To prevent trouble this choice is not saved at power off.
7. Operator TC
The Operator entered TC becomes the next recording session reference.
'OTC' is displayed as timecode flag.
8. Record-Run TC
Record-Run is activated for the full session until another timecode Source is selected; in that case
the clock goes back to its default Free-Run mode.
'RTC' is displayed as timecode flag.
V.Clap Detection
Selects the AutoSlate detection channel.
VI. Mixer Fader Max Level
Mixer's faders top position gain.
VII. Phantom Mic Gain
Let the user decide whether to add an analog gain (+6dB) when the Phantom Mic Power is ON.
VIII.Tone & Beep
1. Tone Level
1kHz tone level.
2. Beep Level
Headphone beep level.
3. Record Beep
Single beep on 'start', double beep on 'stop'.
Double beep is useful to warn you when the video camera stops, while recording in Remote Roll
by LTC.
4. Beep Routing
Let the user decide whether to route the beeps to the outputs or not. (Line outputs, AES outputs,
Cantar X3
57
To Next Page
Loading...