EasyManua.ls Logo

ABB ACS355 series - Control of a Mechanical Brake

ABB ACS355 series
436 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Program features 159
Control of a mechanical brake
The mechanical brake is used for holding the motor and driven machinery at zero
speed when the drive is stopped, or not powered.
Example
The figure below shows a brake control application example.
WARNING! Make sure that the machinery into which the drive with brake
control function is integrated fulfills the personnel safety regulations. Note that
the frequency converter (a Complete Drive Module or a Basic Drive Module, as
defined in IEC 61800-2), is not considered a safety device mentioned in the
European Machinery Directive and related harmonized standards. Thus, the
personnel safety of the complete machinery must not be based on a specific
frequency converter feature (such as the brake control function), but it has to be
implemented as defined in the application specific regulations.
M
230 VAC
Mechanical brake
Power supply
Emergency
brake
X1B
17 ROCOM
18 RONC
19 RONO
Brake control logic is integrated
in the drive application
program. The user has to take
care of the power supply and
wiring.
Brake on/off control is through
relay output RO.
Motor

Table of Contents

Other manuals for ABB ACS355 series

Related product manuals