390 Technical data
Shock
(IEC 60068-2-27,
ISTA 1A)
Not allowed According to ISTA 1A.
Max. 100 m/s
2
(330 ft/s
2
), 11 ms.
According to ISTA 1A.
Max. 100 m/s
2
(330 ft/s
2
), 11 ms.
Free fall Not allowed 76cm (30in) 76cm (30in)
Materials
Drive enclosure • PC/ABS 2 mm, PC+10%GF 2.5…3 mm and PA66+25%GF
1.5 mm, all in color NCS 1502-Y (RAL 9002 / PMS 420 C)
• hot-dip zinc coated steel sheet 1.5 mm, thickness of coating
20 micrometers
• extruded aluminum AlSi.
Package Corrugated cardboard.
Disposal The drive contains raw materials that should be recycled to preserve
energy and natural resources. The package materials are
environmentally compatible and recyclable. All metal parts can be
recycled. The plastic parts can either be recycled or burned under
controlled circumstances, according to local regulations. Most
recyclable parts are marked with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors
and printed circuit boards can be landfilled. The DC capacitors
contain electrolyte, which is classified as hazardous waste within the
EU. They must be removed and handled according to local
regulations.
For further information on environmental aspects and more detailed
recycling instructions, please contact your local ABB distributor.
Applicable standards
The drive complies with the following standards:
• EN ISO 13849-1:
2008
Safety of machinery - Safety related parts of control systems - Part 1:
general principles for design
• IEC/EN 60204-1:
2006
Safety of machinery. Electrical equipment of machines. Part 1:
General requirements. Provisions for compliance: The final
assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device.
• IEC/EN 62061:
2005
Safety of machinery – Functional safety of safety-related electrical,
electronic and programmable electronic control systems
• IEC/EN 61800-3:
2004
Adjustable speed electrical power drive systems. Part 3: EMC
requirements and specific test methods
• IEC/EN 61800-5-1:
2007
Adjustable speed electrical power drive systems – Part 5-1: Safety
requirements – Electrical, thermal and energy
• IEC/EN 61800-5-2:
2007
Adjustable speed electrical power drive systems – Part 5-2: Safety
requirements. Functional.
• UL 508C UL Standard for Safety, Power Conversion Equipment, third edition
To Next Page
Loading...
