350 Fault tracing
How to reset
The drive can be reset either by pressing the keypad key (basic control panel) or
(assistant control panel), through digital input or fieldbus, or by switching the
supply voltage off for a while. The source for the fault reset signal is selected by
parameter 1604 FAULT RESET SEL. When the fault has been removed, the motor
can be restarted.
Fault history
When a fault is detected, it is stored in the fault history. The latest faults are stored
together with the time stamp.
Parameters 0401 LAST FAULT, 0412 PREVIOUS FAULT 1 and 0413 PREVIOUS
FAULT 2 store the most recent faults. Parameters 0404…0409 show drive operation
data at the time the latest fault occurred. The assistant control panel provides
additional information about the fault history. See section Fault logger mode on page
99 for more information.