1 – Power-up, date and time settings
Set the correct date:
•
Use and to move the cursor left and
right.
•
Use and to change the value.
• Press (Save) to accept the new setting.
Check/adjust all the remaining settings in
the Date & time menu.
The Show clock setting determines whether
the time is shown at all times in the bottom
pane of the display.
After you have made the settings, press
(Back or Exit) repeatedly until the Home view
(right) reappears.
2 – Supply voltage and motor data settings
Switch to local control to ensure that external
control is disabled by pressing the
key.
Local control is indicated by the text “Local”
in the top pane.
Note: The ESP control program is active only
in Remote control mode.
Open the main Menu by pressing (Menu).
Highlight Parameters and press (Select).
28 Quick start-up guide
To Next Page
Loading...
