2 – Supply voltage and motor data settings
Highlight Complete list using and and
press (Select).
A listing of parameter groups is displayed.
Highlight parameter group 95 HW configura-
tion and press (Select).
Note that the list wraps around in either dir-
ection between groups 99 and 01. In this case,
it is quicker to use to locate group 95 on
the list.
After selecting a group, a listing of paramet-
ers within the group is displayed.
Highlight parameter 95.01 Supply voltage (if
not already highlighted) and press (Edit).
The available parameter settings are listed.
Highlight the correct setting on the list and
press (Save).
Press (Back) to display the list of parameter groups again. Select parameter group
99 Motor data, and set parameter 99.03 Motor type.
Note: ESP control program supports Asynchronous and Permanent Magnet Synchronous
motors.
Quick start-up guide 29
To Next Page
Loading...
