ABB ACS880 - Page 355

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
10Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
11Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
See Terms and abbreviations (page 169).Other [bit]
- / real32Defines a reference for frequency ramp balancing. The
output of the ramp generator is forced to this value
when balancing is enabled by parameter 28.79 Freq
ramp out balancing enable.
Freq ramp output
balancing
28.78
- / -Frequency ramp balancing reference. For scaling, see
parameter 46.2.
-598.00 ... 598.00 Hz
Not selected / uint32Selects the source for enabling/disabling speed ramp
balancing. See parameter 28.78 Freq ramp output
balancing.
0 = Disabled
1 = Enabled
Freq ramp out
balancing enable
28.79
00Not selected
11Selected
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
10Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
11Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
See Terms and abbreviations (page 169).Other [bit]
- / real32Displays the value of frequency reference source 1
(selected by parameter 28.11 Frequency ref1 source).
See the control chain diagram on page 756.
This parameter is read-only.
Frequency ref act 128.90
- / -Value of frequency reference source 1. For scaling, see
parameter 46.2.
-598.00 ... 598.00 Hz
Parameters 355