ABB ACS880 - Page 600

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
No filter / uint16 (Only visible with a BCU control unit)
Filters the list of drive/inverter types listed by
parameter 95.31 Parallel type configuration.
Note: This parameter cannot be changed while the
drive is running.
Parallel type list
filter
95.30
1All types listed.No filter
2-3 (380…415 V) types listed.400 V
3-5 (380…500 V) types listed.500 V
4-7 (525…690 V) types listed.690 V
5Liquid-cooled -7 (525…690 V) types listed.-7 LC (525-690V)
Not selected / uint16(Visible when 95.30 Parallel type list filter = No filter)
(Only visible with a BCU control unit)
Defines the drive/inverter type if it consists of
parallel-connected modules.
If the drive/inverter consists of a single module, leave
the value at Not selected.
Note: This parameter cannot be changed while the
drive is running.
Parallel type
configuration
95.31
0The drive/inverter does not consist of
parallel-connected modules, or type not selected.
Not selected
-Drive/inverter type consisting of parallel-connected
modules.
-
0.000 / real32Defines the ratio of the step-up transformer.Transformation
ratio
95.40
1000 = 1 / 1000 = 1Step-up transformer ratio.0.000 ... 100.000
0.00 / real32Defines the voltage drop in step-up transformer.Transformation
voltage drop
95.200
100 = 1 / 1 = 1Voltage drop in step-up transformer.0.00 ... 100.00
1 / real32Defines the medium voltage cable length between the
step-up transformer and the motor.
Length of the cable95.201
1 = 1 / 1 = 1Medium voltage cable length.1.00 ... 32000.00
0.000 mm / real32Defines the diameter of the medium voltage side cable.
If this value is not available then a ideal value can be
used.
Diameter of the
cable
95.202
1000 = 1 mm / 1 = 1
mm
Diameter of the medium voltage side cable.0.000 ... 32000.000
mm
0.000 Ohm/km /
real32
Defines the resistance of the medium voltage side
cable. If this value is not available then a copper resistor
value can be used.
Resistance of the
cable
95.203
1000 = 1 Ohm/km / 2
= 1 Ohm/km
Resistance of the medium voltage side cable.0.000 ... 64000.000
Ohm/km
0.000 nH/km / real32Defines the inductance of the medium voltage side
cable. If this value is not available then a single-wire
self inductance model can be used.
Inductance of the
cable
95.204
600 Parameters