4 Repair
4.3.3. Replacement of complete arm system
3HAC027151-001 Revision: B168
© Copyright 2006-2008 ABB. All rights reserved.
7. Fit the lifting device and adjust it as
detailed in the enclosed instructions.
Also fit a hoisting block to the front, used
to adjust the balance of the arm system in
order to lift it completely level.
NOTE!
There is an alternate method of lifting
the complete armsystem described
below.
Art. no. is specified in Required equipment on
page 166.
Make sure the lift is done completely level!
How to adjust the lift is described in the
enclosed instruction to the lifting device!
Read the instructions before lifting!
xx0600003101
• A : Lifting tool
• B : Roundsling
• C : Lifting chain
• D : Hoisting block
Action Note
Continued
Continues on next page
To Next Page
Loading...
