3 Maintenance
3.3.12. Inspection, signal lamp
3HAC027151-001 Revision: B120
© Copyright 2006-2008 ABB. All rights reserved.
3.3.12. Inspection, signal lamp
Location of signal lamp
The signal lamp is located as shown in the figure below.
xx0600003071
Required equipment
Inspection, signal lamp
The procedure below details how to inspect the function of the signal lamp.
A UL signal lamp
B Clamp
C Cable strap, outdoor
D Motor, axis 3
E Attachment screw, M6x8 quality 8-A2F(2 pcs)
Equipment, etc. Art. no. Note
Signal lamp 3HAC10830-1 To be replaced in case of detected
damage.
Standard toolkit - The content is defined in section
Standard toolkit on page 265.
Other tools and procedures may
be required. See references to
these procedures in the step-by-
step instructions below.
These procedures include
references to the tools required.
Action Note
1. Check that the signal lamp is lit, when the motors are
put in operation ("MOTORS ON").
Continues on next page
To Next Page
Loading...
