NoteAction
xx1600001405
Remove the oil filling nipple, put the protect-
ive cap on and put the oil filling hose into
the connection box.
9
Tightening torque: 24 Nm
xx1500001993
Refit the ventilation plug.10
Note
After all repair and maintenance work in-
volving oil, always wipe the robot clean
from all surplus oil. The robot color may
otherwise discolor.
11
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section First test
run may cause injury or damage on
page 27.
12
146 Product manual - IRB 8700
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
3 Maintenance
3.4.2 Changing oil, axis-1 gearbox
Continued
To Next Page
Loading...
