NoteAction
xx1500001995
Remove the inspection plug.4
xx1500002014
Remove the protection cap from the nipple
of the oil filling plug and connect the oil
dispenser.
5
Type of oil and total amount is detailed in
Technical reference manual - Lubrication
in gearboxes.
Refill the gearbox with oil, using the oil
dispenser.
Note
The amount of oil to be filled depends on
the amount previously being drained.
6
See Type of lubrication in gearboxes on
page 140.
Required oil level is:Inspect the oil level at the oil inspection
plug.
7
A few millimeters below the lower edge of
the inspection hole.
More information is found in Inspecting the
oil level in axis-2 and 3 gearboxes on
page 107.
xx1500001995
Continues on next page
Product manual - IRB 8700 151
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
3 Maintenance
3.4.3 Changing oil in axis-2 and axis-3 gearbox
Continued
To Next Page
Loading...
