NoteAction
xx1300000834
Take a hold of the SMB cover and pull the battery
cable out through the recess for the battery.
7
Attachment screws: M6x16 8.8 (5 pcs)Secure the SMB cover.8
Tightening torque: 6 Nm
xx1300000669
If cabling is used for 7th axis (option), refit the
connector R2.FB7 to the SMB cover and tighten
with 6 Nm.
9
Refitting the SMB battery
NoteAction
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the
unit please read the safety information in the
section The unit is sensitive to ESD on page 32
1
Get a hold of the battery cable in the recess for
the battery and reconnect.
2
xx1300000829
Place the battery in the recess.3
Continues on next page
Product manual - IRB 8700 223
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.4.2 Refitting the cable harness
Continued
To Next Page
Loading...
