ABB IRB 8700 Series - Page 608

NoteAction
xx1200001019
Wipe clean the contact surfaces from any
contamination.
Also wipe clean the o-ring groove.
2
O-ring: 3HAB3772-107Make sure the o-ring is undamaged.
Note
Replace if damaged.
3
Lubricate the o-ring with some grease.4
xx1200001020
Make sure the o-ring is seated in the
groove.
5
Continues on next page
608 Product manual - IRB 8700
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.7.4 Replacing the axis-5 motor
Continued