FINAL EXAM
ARCHITECT
®
RSH Service Training Guide EXAM-3
201532-102 FOR INTERNAL USE ONLY
FINAL EXAM NAME:________________________________
1. The Carrier Transport rides on what assembly?
a) Extrusion Rails
b) Carrier Transport Pulley
c) Carrier Transport Spring
d) Carrier Transport Bearing
2. What voltages are developed on the SIB?
a) +1.8DVC, +5VDC
b) +1.8VDC, +3.3VDC
c) +3.3VDC, 5VDC
d) +5VDC, +10VDC
3. What Carrier Transport sensor determines if the Carrier Transport is aligned with a Carrier Positioner
pocket?
a) Rail Guide
b) Section Align
c) Section Carrier Detect
d) Carrier Positioner Align
4. On an i2000SR
®
System, what troubleshooting could you do next if the Carrier Transport motor had
holding current but did not move home.
a) Replace the Carrier Transport
b) Swap Card Cage boards #3 and #14
c) Swap Card Cage boards #2 and #5
d) Set jumpers and switches then swap Card Cage board #2 and #5
5. After installing the Carrier Transport, which M&D is performed first?
a) 1119 Transport Calibration
b) 3317 RSH Test
c) 3323 RSH Section Test
d) 1010 Routine Bay Partition Alignment
6. What must you do when removing the Carrier Transport?
a) Remove 3 captive screws and lift out from Routine Bay Doors
b) Move the transport to the furthest left position
c) Move the transport to the furthest right position
d) Remove the screws and 2 cables then turn it to slide out a Priority Bay Section
Final Exam Page 1 of 2
To Next Page
Loading...
