Chapter 2 Installing Your ARMC/2 Card
Before You Start
Avoid Electro-Static Discharge (ESD)
Electro-Static Discharge (ESD) can damage the ARMC/2 card and other system
components. Keep your ARMC/2 card in its anti-static bag until it is to be installed.
Avoid contact with any component or connector on any adapter card, printed circuit
board, or memory module. Handle these components by the mounting bracket.
Perform all unpacking and installation procedures on a ground-connected anti-static mat.
Wear an anti-static wristband grounded at the same point as the anti-static mat. You can
also use a sheet of conductive aluminum foil grounded through a one megaohm resistor
instead of the anti-static mat. Similarly, a strip of conductive aluminum foil wrapped
around the wrist and grounded through a one megaohm resistor serves the same purpose
as a wristband.
ARMC/2 Installation and Setup
Use the following steps to install the ARMC/2 card into the host system.
Step Action
1 Unpack the ARMC/2 card (and check jumper settings)
2 Plug in the ARMC/2 card into the host system and attach internal cables
3 Connect external cables
4 Confirm the motherboard’s BIOS settings
5 Install the operating system and ARMC/2 card’s drivers
6 Install all ARMC/2 Windows Software Components
7 Setup your client system’s Internet browser
8 Connect to the ARMC/2 from a client system
9 Load the ARMC/2 SDR and Soft Processor (SP) File for your motherboard or
server board model
Note: Inspect the cardboard carton for obvious damage.
ARMC/2 User’s Guide
4
To Next Page
Loading...