Step 2 Plug in the ARMC/2 Card into the Host System and Attach Internal
Cables,
Continued
JP4 and JP5 Chassis/Motherboard Power Switch
JP4 and JP5 can be used in place of the ARMC/2 Universal Cable to power on, power off,
and power cycle the motherboard.
Connect a two pin cable from the motherboard’s Power (Soft On/Off) header to JP4 on
your ARMC/2 card. Connect the chassis power switch to JP5 on your ARMC/2 card.
Note: JP4 and JP5 can be used in place of the ARMC/2 Universal Cable to power on, power
off, and power cycle the motherboard.
JP6 ARMC/2 Reset Button
You can short this jumper to reset your ARMC/2 card.
Pin Description
1 Ground
2 Reset #
JP7 and JP8 Chassis/Motherboard Reset Switch
JP7 and JP8 can be used in place of the ARMC/2 Universal Cable to reset the
motherboard.
Connect a two pin cable from the motherboard’s Reset header to JP7 on your ARMC/2
card. Connect the chassis reset switch to JP8 on your ARMC/2 card.
Note: JP7 and JP8 can be used in place of the ARMC/2 Universal Cable to reset the
motherboard.
Step 3 Connect External Cables
• Connect the USB cable from the back of the ARMC/2 card to the motherboard’s
USB port.
• Connect your VGA monitor to your ARMC/2 card.
• Connect the RJ45 LAN cable from your local network to your ARMC/2 card.
• Connect your AC adapter. (Only if the AC Adapter is part of your ARMC/2 kit)
Cont’d
ARMC/2 User’s Guide
10
To Next Page
Loading...