Appendix I GtkRConsoleARMC2 for Linux
Installation
If you are using a Linux client system to connect to the ARMC/2 card, you can run the
gtkRConsoleARMC2 utility to remotely control the ARMC/2 card and redirect the host
system’s keyboard, video, and mouse.
Note: The gtkRConsoleARMC2 utility must be installed on the remote client system, not the
host system.
Use the following command to run gtkRConsoleARMC2:
rpm -Uvh gtkRConsole-ARMC2-2.6-1.i386
You can also double left click the RPM file located on the ARMC/2 CD if you are using
X windows.
The file is located in the following directory on the ARMC/2 CD:
CDROM\RemoteTools\Linux\
The name of the RPM is as follows:
gtkRConsole-ARMC2-2.6-1.i386
Run the gtkRConsoleARMC2 utility in terminal mode.
gtkRConsole-armc2 <ARMC/2 IP Address>
ARMC/2 User’s Guide
144
To Next Page
Loading...