Appendix C ARMC/2 Remote Recovery
Application (RRA)
ARMC/2 Card Remote Recovery Application (RRA)
The Remote Recovery Application (RRA) is a recovery tool that can be executed from a
remote client system located on the same network as the ARMC/2 card. You can use it to
recover a failed flash attempt.
To run the ARMC/2 Remote Recovery Application (RRA), double left click on the
RRA.exe icon.
Note: You must physically set the ARMC/2 card you want to recover into Recovery Mode. To
do this, simply short pins two and three on jumper JP12 on your ARMC/2 card.
Note: Your ARMC/2 card must be write enabled before you can flash an image to it. Confirm
that pins one and two on jumper JP11 are shorted on your ARMC/2 card.
Note: The firmware upgrade process is a crucial operation. Make sure that the chances of a
power or connectivity loss are minimal when performing this operation.
Note: You must configure the card parameters before you can start flashing your ARMC/2
card’s firmware.
Cont’d
Appendix D : Troubleshooting
125
To Next Page
Loading...