WinCuri, Continued
WinCuri.exe Help File, Continued
Script mode Commands:
-----------------------------
Script file format is any of the other argument formats mentioned below
For e.g : WinCuri -script myscr.scr
-script ScriptFile
myscr.scr can contain the fllowing lines if you want to get all users and
then get network config
-user -listall
-net -getconfig
User Manger Commands
-----------------------------
-user -add username password
-user -del username password
-user -add username password auth pvt
-user -listAllUser
-user -listAll
-user -getSnmp
System Event Log (SEL) Commands
-----------------------------
-sel -listAll
-sel -selInfo
-sel -clear
-sel -setPolicy <ROLLOVER | STOP>
-sel -getPolicy
Platform Event Filtering (PEF) commands
-----------------------------
-pef -ARInfoSet index name mailId SNMPDest PPPID NotifyMethod NotifyMedium
PPPPass AlertType
NotifyMethod can be "Mail" or "SNMP" and
NotifyMedium can be "Lan" or "PPP"
AlertType can be All,Disable or Critical
-pef -ARInfoGet index
Firmware flasher commands
-----------------------------
-flash -read filename
-flash -update [-boot] filename
-flash -saveconfig
-flash -saveSDK
-flash -getconfig filename
-flash -putconfig filename
-flash -compareboot filename
Network configuration commands
-----------------------------
-Net -GetMac
-Net -SetMac <MAC Address> - <Ex: 00:2a:3b:4c:5d:1d>
-Net -GetConfig
-Net -SetDHCP
-Net -SetSTATIC IP Netmask Gateway
Cont’d
Appendix D : Troubleshooting
121
To Next Page
Loading...