85
1. Connect to DUT
Refer to Figure 19 or 20 and the type of reference sensor, to measure the TC or RTD. Then refer to Figure 7 or 8
to measure the voltage or circuit based on the transmitter’s output type.
2. Create the task
Refer to paragraph 6.2.2.
3. Task setting
Refer to the task setting in paragraph 6.1.1.
4. Start the task
For part of the content, refer to “Start the Task” in paragraph 6.1.1.
During the task, the calibrator simulates and outputs a temperature signal to the DUT and measures and records
the electrical signal output of the DUT. No manual input required.
5. Finish the task
Refer to “Finish the Task” in paragraph 6.1.1.
To Next Page
Loading...
