Additel 226Ex - Calibrating Temperature Devices; Temperature Indicators

79
4. Start the task
 For part of the content, refer to Start the task in paragraph 6.1.1
 During the task performing, the calibrator will output the corresponding current according to the set point list, and
automatically record the DUT output pressure, without manual input.
5. Finish the task
Refer to Finish the task in paragraph 6.1.1
6.2 Calibrate temperature devices
6.2.1 Temperature indicator
1. Connect to DUT
 Connect the DUT input to the TC output (Figure 23) or RTD (Figure 24) output of the calibrator.
2. Create the task
Create the corresponding DUT tasks as described above and fulfill the necessary information.