Adtech ADT-HC4500 - Page 54

ADT-HC4500 Flame/Plasma Cutting Machine CNC System
- 53 -
󳯙 Delete
󰣗󳔈󱉊 Switch input method / 󱷣󰄏 OK /󱋽 Cancel
󳕾 Up
󲕰󳷪 Page-up /󳕾 Down /󲕰󳷪 Page-down
After entering, press [OK]; if the file name already exists in the system, press [OK], and the system will
prompt, as shown in Fig. 3.1.1.2 below, or else enter the file edit interface, as in Fig. 3.1.1.3;