ADT-HC4500 Flame/Plasma Cutting Machine CNC System
- 88 -
[Cancel] and connect the power to burn the latest program into BIOS chip. Refer to 6.6 for specific operation.
Fig. 6.5.1.1 USB cable
6.5 Burning program
After transmitting the latest software to the controller, you need to save the software in the BIOS of the
controller, making the controller be able to execute the latest software. Operation procedure: turn off the
controller, press and hold [Cancel] on the panel and connect the power to have the interface below:
To Next Page
Loading...