ADT-HC4500 Flame/Plasma Cutting Machine CNC System
- 70 -
Reverse
clearance (Y)
Clearance compensation for axis Y during reverse direction
change
mm
Table 4.3.1
4.4 Control
In Fig. 4 system parameter setting interface, press [F4] to show the interface below, in which you can set X, Y
motor speed, preheating and torch up/down time during automatic processing.
Flame Control Parameter Interface
Edge perforating prompt: Off
Preheating delay
Torch up delay
Torch down delay
Ignition delay
Perforating torch up
Perforating torch down
Perforating delay
Slot compensation
Return / System / Speed / Adjust / Control / Precision / Store /
Return
Fig. 4.4.1 p
Flame
To Next Page
Loading...