Adtech ADT-HC4500 - Adjusting Preheating Time While Flame Cutting

ADT-HC4500 Flame/Plasma Cutting Machine CNC System
- 18 -
0.010000-0.011000 100
0.011000-0.012000 110
0.012000-0.013000 120
Table 2.8.2
9. Adjusting preheating time while flame cutting
In the main menu interface, press [F4] (Parameter)  [F4] (Control), and set the “Preheating delay” in the
second line to desired time.
󱗠󱚥󰤜󰫥󱫁󳳗 Flame Control Parameters
󳔮󲒍󱿴󰃉󰥅󱺯 Edge perforation prompt: 󳭢󰥅󱺯OFF
󳷹󱙢󰑫󰭫 Preheating delay:
󰴟󰑫󰭫 Torch up delay:
󰴟󳯂󰑫󰭫 Torch down delay:
󱘮󱗠󰑫󰭫 Ignition delay:
󱿴󰃉󰴟 Perforation torch up:
󱿴󰃉󰴟󳯂 Perforation torch down:
󱿴󰃉󰑫󰭫 Perforation delay:
󲒒󲷚 Slot compensation:
󳕉 Return /󲉰󲑔 System / 󳖔󰐛 Speed / 󳅸󰫩 Adjust /󰤜 Control / 󲈳󰐛 Precision / 󰃍 Store /󳕉