ADT-HC4500 Flame/Plasma Cutting Machine CNC System
- 66 -
Flame Step Height Adjustment Setting
Z Allow Z axis height adjustment: Off
Z Z axis pulse equivalent
Z Z axis start speed
Z Z axis acceleration
Z Z axis maximum speed:
Torch up/down distance
Perforating up/down distance:
Return / Configure / Adjust height / Advance / Flame / Save / Return
Fig. 4.1.2 Flame Step Height Adjustment
Parameter description:
1) Allow Z axis height adjustment: If the state is on, connect to axis Z of the system to adjust the
torch height while flame cutting.
2) Z axis pulse equivalent: Z axis precision setting; please refer to section 4.5.1 (Pulse equivalent
setting)
3) Z axis start speed: Please refer to section 4.2.1 (Speed setting)
4) Z axis acceleration: Please refer to section 4.2.1 (Speed setting)
5) Z axis end speed: Please refer to section 4.2.1 (Speed setting)
6) Torch up/down distance: The distance dropping to preheating height (cutting) for the first time
while cutting (the distance that torch rises from cutting height to initial height)
To Next Page
Loading...