ADTRAN MX2800 STS-1 - Page 150

9-22 61204659L1-1A
Section 9, Transaction Language 1 (TL1) MX2800 STS-1 User Manual
TL1 Error Codes
VTAISRLY Y/N Y or [N] Provisions alarm relay response for the VT
AIS alarm
• Yes (Y) - enables alarm relay response
• No (N) - disables alarm relay response
VTCFGMODE ENUM One of the following:
•T1
•E1
Identifies VT1 Configuration
• T1 sets VT1 configuration to M12 (4xT1).
• E1 sets VT1 configuration to G.747
(3xE1).
VTCFGSTATE ENUM One of the following:
•DISABLE
•ENABLE
•AUTO
•UNAVAIL
State (returns UNAVAIL if VT is
unequipped)
VTCFGCIRCUITPROT ENUM One of the following:
•DISABLE
•ENABLE
•UNAVAIL
Circuit protection (returns UNAVAIL if VT
is unequipped)
VTLBKDETECTION ENUM One of the following:
•DISABLE
•CSU
•NIU
•UNAVAIL
Loopback detection (returns UNAVAIL if
VT is unequipped)
VTHAIRPINNING ENUM One of the following:
•DISABLE
•ENABLE
•UNAVAIL
VT Hairpin status (returns UNAVAIL if VT
is unequipped)
VTLOPRLY Y/N Y or [N] Provisions alarm relay response for the VT
LOP alarm
• Yes (Y) - enables alarm relay response
• No (N) - disables alarm relay response
VTMAPPING ENUM 1, 2, 3, ..., 28
UNEQUIPPED
T1/E1 port to which the VT is mapped
VTRFIRLY Y/N Y or [N] Provisions alarm relay response for the VT
RFI alarm
• Yes (Y) - enables alarm relay response
• No (N) - disables alarm relay response
Table 9-7. TL1 Editing Data Dictionary for VT1 (Continued)
Keyword Type Domain Description