ADTRAN MX2800 STS-1 - Load Default Settings

3-38 61204659L1-1A
Section 3, Configuration MX2800 STS-1 User Manual
Utilities
Load Default Settings
Select Load Default Settings from the Utilities menu. The screen displays the following message:
!WARNING! Defaulting configuration will disrupt traffic on all ports.
Select Confirm to proceed or press ESC to abort.
NOTE
The IP Address, Default Gateway, and subnet mask are not reset when
default settings are loaded.
NOTE
Loading the default settings resets the User Account Management table to
a single default account adtran/adtran/admin.
Table 3-14. Self-Test Results
If the self test results are... Then...
PASS The self-test was successful and the unit is ready to use.
BAD RAM DATA
BAD RAM ADDRESS
BAD CODE CHECKSUM
BAD BOOT SECTOR
IOX PROGRAM FAILURE
AFE PROGRAM FAILURE
MODEM FAILURE
ETHERNET FAILURE
STS-1 FAILURE
DSX FAILURE
Contact ADTRAN Technical Support.
CONFIGURATION CORRUPT Select S
AVE CONFIGURATION from the main CONFIGURATION menu. If con-
dition persists, contact ADTRAN Technical Support.