3-42 61204659L1-1A
Section 3, Configuration MX2800 STS-1 User Manual
Utilities
System Reset
The system must be manually reset after downloading new software. When the unit has successfully
loaded and programmed the new software into its FLASH memory, it uploads the code to the standby
controller that is indicated on the menu. The
STATUS LED on the standby controller displays solid yellow
during this process.
CAUTION
The standby card must remain in place until the process is complete and
the
STATUS LED is no longer solid yellow. Removing the standby card
during the uploading process corrupts the software.
Once the upload is complete, the standby card resets and begins running the new code. However, the active
card does not reset automatically. The unit must be reset using either of these options, as required:
• Immediate Reset
• Scheduled Reset Time
To Next Page
Loading...
