Advantech ICR-1601 - Page 76

ICR-1601
76
Profile Configuration
Item
Value setting
Description
Profile Name
1. String format can
be any text
2. A Must filled
setting
Enter a profile name for the uplink network specified below. It is a name that
is easy for you to understand.
Value Range: 1 ~ 64 characters.
Network ID (SSID)
1. String format : Any
text
2. The box is checked
by default.
Enter the SSID for the VAP, and decide whether to broadcast the SSID or not.
The SSID is used for identifying from another AP, and client stations will
associate with AP according to SSID. If the broadcast SSID option is enabled, it
means the SSID will be broadcasted, and the stations can associate with this
device by scanning SSID.
Channel
1. A Must filled
setting.
2. Auto is selected by
default.
Select a radio channel for the VAP. Each channel is corresponding to different
radio band. The permissible channels depend on the Regulatory Domain.
There are two available options when Auto is selected:
 By AP Numbers
The channel will be selected according to AP numbers (The less, the
better).
 By Less Interference
The channel will be selected according to interference. (The lower, the
better).
Authentication
1. A Must filled
setting
2. Open is selected by
default.
Specify the authentication method for connecting with the uplink network. It
can be Open, Shared, WPA-SPK, or WPA2-PSK.
When Open is selected, the pre-shared WEP key could be set for
authentication;
When Shared is selected, the pre-shared WEP key should be set for
authentication;
When WPA-PSK or WPA2-PSK is selected, The TKIP or AES pre-shared key
should be set for authentication;