Advantech ICR-1601 - Page 77

ICR-1601
77
Encryption
1. A Must filled
setting.
2. None is selected
by default.
Select a suitable encryption method and enter the required key(s).
The available method in the dropdown list depends on the Authentication
you selected.
None
It means that the device is open system without encrypting.
WEP
Up to 4 WEP keys can be set, and you have to select one as current key. The
key type can set to HEX or ASCII.
If HEX is selected, the key should consist of (0 to 9) and (A to F).
If ASCII is selected, the key should consist of ASCII table.
TKIP
TKIP was proposed instead of WEP without upgrading hardware. Enter a Pre-
shared Key for it. The length of key is from 8 to 63 characters.
AES
The newest encryption system in WiFi, it also designed for the fast 802.11n
high bitrates schemes. Enter a Pre-shared Key for it. The length of key is from
8 to 63 characters.
You are recommended to use AES encryption instead of any others for
security.
MAC Address
1. MAC Address
string Format
2. A Must fill setting
Specify the MAC Address of the access point (with the Network ID) to be
connected to.
Priority
1. An Optional filled
setting.
2. 16 is set by
default.
Specify a priority setting for the uplink profile when the By User-defined
methodology is selected. The priority value can be 1 ~ 16. 1 is the highest
priority, and 16 is the lowest priority).
Enable
The box is checked
by default.
Click the Enable box to activate this profile.
Save
N/A
Click the Save button to save the configuration.
Undo
N/A
Click the Undo button to restore what you just configured back to the
previous setting.
Back
N/A
When the Back button is clicked, the screen will return to the Profile List
page.
Instead of manually enter the information for the uplink network, you can also click the Scan button
to get the available wireless networks around the device, and select one as the uplink network.
When the Scan button is applied, Wireless AP List will appear after few seconds.