Safety
Safety Guidelines for Operating the Machine 3.2
17
[en-US] | 08/2022 | 5100064108 | SM100 | Operator’s Manual
• Contact the person responsible for jobsite utilities. Follow their recom-
mendations for support and securing of utility lines.
Risk zone awareness
• The risk zone is the area in which persons are at risk due to the move-
ments of the machine, work equipment, additional equipment, or mate-
rial.
• Stop work immediately if persons do not leave the risk zone in spite of
warnings.
• The risk zone also includes areas affected by falling material, equipment,
or constructions debris. For further information, see Risk of Injury or
Death on page 35.
Before machine operation
The machine, including all components, safety devices, labels, and attach-
ments must be in good condition before use.
• If the machine is functioning unpredictably or in event of malfunctions,
turn off the machine immediately, remove the key, and report the mal-
function to a qualified technician or supervisor. Safety-relevant damage
or malfunctions of the machine must be repaired immediately.
Machine operation
• When stepping on or off the operator platform, face the machine and use
three points of contact.
• Keep the attachments or work equipment close to the ground. Keep the
load low when moving on slopes—up, down, and across.
• Do not get on or off a moving machine, and do not jump off the machine.
• Remain aware of the machine’s moving parts. Keep hands, feet, and
loose clothing away from the machine’s moving parts.
• Know the machine’s lifting capacity. Do not exceed the ROC for the ma-
chine. For further information, see Forces on page 112.
• Do not use a mobile device while operating this machine.
• Do not allow anyone underneath a raised load.
• Do not leave the machine running unattended.
• Do not operate the machine before it has reached its operating tempera-
ture.
• Do not consume the operating fluids used in this machine.
• Do not use the machine as a crane. These loaders are not approved for
craning applications. These craning applications include raising, trans-
porting, and lowering point loads with the help of slings and load-secur-
ing devices (for example, ropes and chains). This applies, for example,
to lifting and lowering pipes, shaft rings or containers.
PPE
Wear the following PPE while operating this machine:
3
To Next Page
Loading...
Need help?
General